(with one and 2 point over the caldrun) and then a blank screen,
no way to have a console
booting without additional parameters on the command line and selecting NO_ACPI,
I can see the boot procedure on the console,
it stops after these lines:
[FAILED] failed to start wait for plumouth Boot screen
[OK] Reached target multi-user
[OK] Reached target Graphical Interface
going on a different screen have a console,
in jounalctl I can read
systemd-readahed: "Out of memory" (in red)
but free -m says I have still 3GB free
My vga is an Intel card, these are the details from MGA2
- Code: Select all
tom@localhost Desktop]$ lspci | grep -i vga
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Integrated Graphics Controller (rev 07) (prog-if 00 [VGA controller])
Subsystem: Samsung Electronics Co Ltd Device c060
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 43
Region 0: Memory at fa000000 (64-bit, non-prefetchable) [size=4M]
Region 2: Memory at d0000000 (64-bit, prefetchable) [size=256M]
Region 4: I/O ports at 1800 [size=8]
Expansion ROM at <unassigned> [disabled]
Capabilities: <access denied>
Kernel driver in use: i915