MegaSync Client Mageia 5,6 & 7

[katnatek]

Thanks to a contibution of MLO community MegaSync Client is in BlogDrake's repositories (Version 3.1.4 for MGA 5, 4.0.2.0 for MGA 6 & 4.1.1.0 for MGA 7)
Just add the set that match your system architecture

i586:

Code: Select all

urpmi.addmedia --wget --distrib http://ftp.blogdrake.net/mageia/mageia7/i586

x86_64:

Code: Select all

urpmi.addmedia --wget --distrib http://ftp.blogdrake.net/mageia/mageia7/x86_64

and install

Code: Select all

urpmi megasync

For the package for Mageia 5 and 6, just change 7 to 5 or 5 in the urpmi.addmedia command.
And remember than from Mageia 6 our repository can be added to dnf repositories

[caffilhobr]

Thanks for the info, I installed it on Mageia 6 today and it worked correctly.

[fmolina2b]

Hi katnatek,
Thank you for the tip. I installed v3.7 from the French site: https://www.mageialinux-online.org/foru ... 49#m237540
Note that version 4 of the megasync client is now available at github: https://github.com/meganz/MEGAsync
Perhaps it could be built for Mageia at some time.
Regards

[doktor5000]

Please keep in mind that the OP is from over a year ago ...

[fmolina2b]

Yes, but in the French MLO site they keep updating, last one is of September

[katnatek]

Hi katnatek,
Thank you for the tip. I installed v3.7 from the French site: https://www.mageialinux-online.org/foru ... 49#m237540
Note that version 4 of the megasync client is now available at github: https://github.com/meganz/MEGAsync
Perhaps it could be built for Mageia at some time.
Regards

I will see but i don't make any promise.
Our last version is megasync-3.6.6.0 for maga6 so is good time to update at less the mga6 version

[fmolina2b]

No hurry with that. Thank you!

[katnatek]

Ready the version 4.0.2.0

[fmolina2b]

Thanks a lot!
But, where is it? I can't find it at https://www.mageialinux-online.org/forum/topic-23749+mega-sync-client.php

[katnatek]

Thanks a lot!
But, where is it? I can't find it at https://www.mageialinux-online.org/forum/topic-23749+mega-sync-client.php

Its in the blogdrake repository, see the first message of this thread for instructions
This time the build for x86_64 was made for one of our volunteers so i forget to notify the MLO community

[fmolina2b]

Perfect, thanks!