Mageia forum

Mageia 2 0n Inspiron N5010. bluetooth shows enabled in BIOS and WL broadcom shows as eth1 and is working fine but Neither MCC, Blutooth in "configure you computer" or lspci show bluetooth adapter but apparently this laptop does have it:

lspci

Code: Select all

00:00.0 Host bridge: Intel Corporation Core Processor DRAM Controller (rev 18)
00:02.0 VGA compatible controller: Intel Corporation Core Processor Integrated Graphics Controller (rev 18)
00:16.0 Communication controller: Intel Corporation 5 Series/3400 Series Chipset HECI Controller (rev 06)
00:1a.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset High Definition Audio (rev 06)
00:1c.0 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 1 (rev 06)
00:1c.1 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 2 (rev 06)
00:1c.2 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 3 (rev 06)
00:1c.4 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 5 (rev 06)
00:1d.0 USB controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev a6)
00:1f.0 ISA bridge: Intel Corporation Mobile 5 Series Chipset LPC Interface Controller (rev 06)
00:1f.2 SATA controller: Intel Corporation 5 Series/3400 Series Chipset 6 port SATA AHCI Controller (rev 06)
00:1f.3 SMBus: Intel Corporation 5 Series/3400 Series Chipset SMBus Controller (rev 06)
00:1f.6 Signal processing controller: Intel Corporation 5 Series/3400 Series Chipset Thermal Subsystem (rev 06)
12:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller (rev 01)
13:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 02)
ff:00.0 Host bridge: Intel Corporation Core Processor QuickPath Architecture Generic Non-core Registers (rev 05)
ff:00.1 Host bridge: Intel Corporation Core Processor QuickPath Architecture System Address Decoder (rev 05)
ff:02.0 Host bridge: Intel Corporation Core Processor QPI Link 0 (rev 05)
ff:02.1 Host bridge: Intel Corporation Core Processor QPI Physical 0 (rev 05)
ff:02.2 Host bridge: Intel Corporation Core Processor Reserved (rev 05)
ff:02.3 Host bridge: Intel Corporation Core Processor Reserved (rev 05)


although rfkill shows:

0: dell-wifi: Wireless LAN
Soft blocked: no
Hard blocked: no
1: dell-bluetooth: Bluetooth
Soft blocked: no
Hard blocked: no


lsusb shows:
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 002: ID 8087:0020 Intel Corp. Integrated Rate Matching Hub
Bus 002 Device 002: ID 8087:0020 Intel Corp. Integrated Rate Matching Hub
Bus 001 Device 003: ID 0c45:6480 Microdia Sonix 1.3 MP Laptop Integrated Webcam
Bus 002 Device 003: ID 0a5c:4500 Broadcom Corp. BCM2046B1 USB 2.0 Hub (part of BCM2046 Bluetooth)
Bus 002 Device 004: ID 413c:8161 Dell Computer Corp. Integrated Keyboard
Bus 002 Device 005: ID 413c:8162 Dell Computer Corp. Integrated Touchpad [Synaptics]

Some threads indicate this was working in Mag1 but now not available in Mag2

Any ideas appreciated

Trio3b wrote:lsusb shows:
[...]
Bus 002 Device 003: ID 0a5c:4500 Broadcom Corp. BCM2046B1 USB 2.0 Hub (part of BCM2046 Bluetooth)

it seems to be an usb device, so cannot be listed by lspci.

these commands should give some more details about it:

Code: Select all

hcitool dev
hciconfig -a
hcitool scan
dmesg | grep Bluetooth


here there is also a discussion related to that device:

http://forums.linuxmint.com/viewtopic.php?f=141&p=324733

opened laptop and discovered someone in there before me had left out hold down screw for BT adapter, thinking maybe it provided a ground but no luck so back to software.
I have heard that this device is toggled by Win 7 software ( then it can be used in linux) but of course there is no Windoze available around here.

hci* show no devices listed


dmesg | grep Blutooth output is :

[user@inspiron ~]$ dmesg | grep Bluetooth
[ 52.740848] Bluetooth: Core ver 2.16
[ 52.740879] Bluetooth: HCI device and connection manager initialized
[ 52.740882] Bluetooth: HCI socket layer initialized
[ 52.740884] Bluetooth: L2CAP socket layer initialized
[ 52.740889] Bluetooth: SCO socket layer initialized
[ 52.749625] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 52.749628] Bluetooth: BNEP filters: protocol multicast



Does this sound like a safe thing to try? -> http://code.google.com/p/broadcom-bluetooth/wiki/USB although there is no btusb directory, only /sys/bus/usb/drivers/ -> hub,usb, usbfs, usbhid, ucvvideo

[UPDATE] installed <bluez-hid2hci> package and now have blootooth icon and bluetooth adapters seen in system settings. Will check paired devices and mark solved when checked.

Thanks

Very strange. Am able to pair devices now but browsing files via Dolphin only shows one folder and a few .jpg images. The rest of images on cellphone must be pushed only 10 at a time over to the laptop. Had this setup in LinuxMint Xfce on another machine and all pics available for browsing via Thunar.

Any ideas what's up?