[SOLVED] Freecad Compile Q RPM done ! (MGA4 Builds!!!)
Posted: Jul 25th, '13, 01:33
Managed to compile Freecad on mageia 3(64 bit) tonight ( Finally ) apart from the fem module don't work the rest is working fine
Have got all the dep's sorted I think also
Going to have a go at doing an rpm build over the weekend but the spec file kinda bamboozles me So wish me luck
I've read the guide an all but erm, still.
There are a couple of other dep's that also ain't in the repos so going to have to do them as well.
However any insight to the fem(Machining distortion work bench) module would be appreciated though.
Might have to do a post on there forums I suppose but thought I'd ask here first!
Pete.
ps. There might be a post pop up on rpm building later on in the week/end
Have got all the dep's sorted I think also
Going to have a go at doing an rpm build over the weekend but the spec file kinda bamboozles me So wish me luck
I've read the guide an all but erm, still.
There are a couple of other dep's that also ain't in the repos so going to have to do them as well.
However any insight to the fem(Machining distortion work bench) module would be appreciated though.
Might have to do a post on there forums I suppose but thought I'd ask here first!
Pete.
ps. There might be a post pop up on rpm building later on in the week/end